MasterCraft X-15 Installationshandbuch PDF herunterladen (Seite 20)

20 Holland Marine Parts / MasterCra | Installaon manual and user guide

1: Place vessel horizontal. Select opmum posion for nozzle: As far to the front of bow or

stern as possible, top side of nozzle 10cm / 4” below water line. Nozzle horizontal and in 90˚

angle to the heart line of the vessel.

Note: Not placing the nozzles as far to the front or a as possible reduces the overall

eecveness of the system!

Laser equipment can assist selecng opmum posion and determine if vessel is placed

perfectly horizontal.

2: Make sure the posion of both nozzles and the components like the ball valves, elbows, hose

connector, hoses and hose clamp are not in conict with available space before a hole is made.

Drill a pilot hole. Keep drill horizontal!

Nozzles can be posioned shied horizontal and vercal in case of a narrow bow. Hoses can

be crossed in order to place the nozzles further to the front of the bow. See image at point 8

for visible explanaon.

3-4: Use a 60mm / 2⅜” hole saw to drill the holes

for the nozzle.

Keep drill horizontal and in 90˚ posion to the vessel’s

heart line. (see illustraon page 30)

5: Smoothen edges

6: Fit in the nozzle and check if nozzle is placed horizontal and in 90˚ angle to the heart line of

the vessel e.g. by inserng the nozzle from the inside out to determine if hole is drilled correct.

10 Installing the nozzles

In case of steel or aluminum vessel plang weldable nozzles are available.

For polyester and wooden vessel plang ange treaded nozzles are available.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Keine Kommentare

MasterCraft X-15 Installationshandbuch Seite 20